We would recommend either sending the red dot back for an exchange to whichever seller you purchased it from, or open up the holes in the bottom of the red dot to accommodate the pins. These dots may not fit properly on the posts on the plate. Please note: We have found that some red dots commonly found on Amazon such as the UTG and ADE may not hold the same tolerances as the red dots that this mount was initially created to work with. Regardless, the windage is maxed out to the right, and I still hit left. I installed new Wilson combat sights ( Theyre very nice). Mounting Hardware is Included This mount fits:Colt Gold CupColt Trooper Mark 3Colt Python (does NOT fit 2020 and newer models)Colt Anaconda (does NOT fit 2020 and newer models) This is for Colt models with the Elliason style adjustable rear sight.The elevation screw from the original rear sight is re-used in the center hole on this mount unless you have an Anaconda. *All ADE mounts require 6-32 x 3/8" screws. I have a 2nd generation Colt Anaconda, and its 'Bad to the Bone,' Ive been shooting reduced loads out of it, 17.4 grs of 2400 behind a coated 240gr bullet. The mounting screws require a 5/64" wrench and the set screws (when applicable) require a 1/16" wrench. (1) 4-48 X 3/8 Mounting Screw (to mount the plate to the frame) (1) 6-40 X 3/8 Mounting Screw (to mount the plate to the frame)
Colt anaconda scope mount driver#
(2) 6-32 x 3/8" Flat Head Screws - Requires 5/64 Wrench or Driver
(2) 6-32 x 5/16" Button Head Screws - Requires 5/64 Wrench or Driver
0 kommentar(er)
